Services Processing Cards

Services Processing Cards (SPCs) are common form-factor module (CFM) cards that provide the processing power to run integrated services such as firewall, IP Security (IPsec), and Intrusion Detection and Prevention (IDP). All traffic traversing the services gateway is passed to an SPC to have services processing applied to it. Traffic is intelligently distributed by Network Processing Cards (NPCs) to SPCs for services processing, including session setup based on policies, fast packet processing for packets that match a session, encryption and decryption, and Internet Key Exchange (IKE) negotiation.

  • If a CFM slot is not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to circulate properly through the device.
  • The ONLINE button on SPC does not perform any function and currently it is not supported.

Figure 66 shows an SPC that can be used on an SRX1400 Services Gateway.

Figure 66: Services Processing Card

Image g036032.gif

Table 54 describes the SPC behavior indicated by the LEDs on its front panel.

Table 54: Services Processing Card LED Indicators

Label

Color

Status

Description

SERVICE

Green

On steadily

The SPC is running under acceptable load.

Amber

On steadily

The SPC is overloaded.

Red

On steadily

No service is being provided by the SPC.

Dark (unlit)

Off

The SPC is not enabled.

OK/FAIL

Green

On steadily

The SPC is operating normally.

Green

Blinking

The SPC is preparing for an online insertion and removal event.

Red

On steadily

The SPC has failed and is not operating normally.

Dark (unlit)

Off

The SPC is powered down.

Related Documentation