1-Port Gigabit Ethernet SFP Mini-Physical Interface Module Basic Configuration

To enable the 1-Port Gigabit Ethernet small form-factor pluggable Mini-Physical Interface Module (SFP Mini-PIM) installed on the SRX Series Services Gateway, you must configure the basic settings for the PIM. You can perform the configuration tasks for this using either the J-Web interface or the CLI.

Using the J-Web Interface

To perform basic configuration of the 1-Port Gigabit Ethernet SFP Mini-PIM and to configure network interfaces for the services gateway using the J-Web interface:

  1. In the J-Web interface, select Configure>Interfaces>Ports.

    The Interfaces page is displayed and lists the network interfaces present on the services gateway, along with configuration information (if the device is configured).

  2. To configure properties for a network interface (Mini-PIM), select the interface name, and click Edit.
  3. To use the port on the Mini-PIM, you must assign it to a security zone other than the Null zone. Optionally, you can also assign the port an IP address (for example, 192.168.3.1/24). Enter or select the following settings:

    Note: The configuration settings given in the following steps are an example. The actual configuration settings might vary depending on your requirements.

    1. Select Configure>Security>Zones/Screens.
    2. Add or select a security zone other than Null; for example, Trust.
    3. For host inbound traffic, set the following:
      • Services=telnet
      • Protocols=ospf
    4. Click OK, and click Commit to apply the configuration and other pending changes (if any).
  4. To use the port on the Mini-PIM, you must also set security policies. Select the following settings:
    1. Select Configure>Security>Policy>Apply Policy.
    2. Set Policy Action: Default Policy Action=from-zone trust to-zone trust.
    3. Click OK to save changes, and click Commit to apply the configuration and other pending changes (if any).

    For advanced configuration information, see the Junos OS Network Interfaces Configuration Guide.

Using the CLI

To perform basic configuration of the 1-Port Gigabit Ethernet SFP Mini-PIM and to configure network interfaces for the services gateway with the CLI:

Note: The configuration settings given in the following steps are an example. The actual configuration settings might vary depending on your requirements.

Related Documentation