2-Port 10-Gigabit Ethernet XPIM Basic Configuration

To enable the 2-Port 10-Gigabit Ethernet XPIM installed on the SRX Series Services Gateway, you must configure the basic settings for the PIM. You can perform the configuration tasks for this using the J-Web interface, the Point and Click CLI, or the CLI.

Using the J-Web Interface

To perform basic configuration for the 2-Port 10-Gigabit Ethernet XPIM and to configure network interfaces for the services gateway using the J-Web interface:

  1. In the J-Web interface, select Configure>Interfaces>Ports.

    The Interfaces page lists the network interfaces present on the services gateway. Verify whether the interface has been configured by reviewing the information in the Configured column (yes/no).

  2. Select the interface name to edit.
  3. To use the port on the XPIM, you must assign it to a security zone other than the Null zone. Optionally, you can also assign the port an IP address (for example, 192.168.3.1/24). Enter or select the following settings:
    1. Select Configure>Security>Zones.
    2. Add or select a security zone other than Null; for example, Trust.
    3. For host inbound traffic, set the following:
      • System Services=Allow All
      • Protocols=Allow All
    4. Click OK, and click Commit to apply the configuration and other pending changes (if any).
  4. To use the port on the XPIM, you must also set security policies. Select the following settings:
    1. Select Configure>Security>Policy>Apply Policy.
    2. Set Policy Action: Default Policy Action=Permit-All.
    3. Click OK to save changes, and click Commit to apply the configuration and other pending changes (if any).

Note: You cannot configure the mode and speed options for the 2-Port 10-Gigabit Ethernet XPIM using the J-Web interface. You must either use the Point and Click CLI or the CLI to configure them.

For advanced configuration information, see the Junos OS Network Interfaces Configuration Guide.

Using the Point and Click CLI to Set Interface Mode and Speed Options

To set the interface mode and speed options for the 2-Port 10-Gigabit Ethernet XPIM with the Point and Click CLI:

  1. From the J-Web interface main menu, select Configure>CLI Tools>CLI Tools>Point and Click CLI.
  2. Next to Interfaces, click Configure or Edit. The Interfaces page displays.
  3. Click the Interface name or click Edit. The details page for the specified interface appears.
  4. To set the mode for the 2-Port 10-Gigabit Ethernet XPIM, select either fiber or copper from the Mode drop-down list box.

    Note: By default, interfaces run in fiber mode at 10 G speed with autonegotiation.

  5. To set the speed for the 2-Port 10-Gigabit Ethernet XPIM, select 10m, 100m, 1g, or 10g, from the the Speed drop-down list box.

    Note: For copper ports, all 10 Mbps, 100 Mbps, 1 G, and 10 G speeds are supported; for fiber ports, only 1 G and 10 G speeds are supported.

  6. Click OK to save changes, and click Commit to apply the configuration and other pending changes (if any).

For advanced configuration information, see the Junos OS Network Interfaces Configuration Guide.

Using the CLI

To perform basic configuration for the 2-Port 10-Gigabit Ethernet XPIM and to configure network interfaces for the services gateway with the CLI:

Related Documentation