Quad CT1/E1 GPIM Basic Configuration

To enable the Quad CT1/E1 Gigabit-Backplane Physical Interface Module (GPIM) installed on the SRX Series Services Gateway, you must configure the basic settings for the PIM. You can perform the configuration tasks for this using either the J-Web interface or the CLI.

Using the J-Web Interface

To perform basic configuration for the Quad CT1/E1 GPIM and to configure network interfaces for the services gateway using the J-Web interface:

  1. In the J-Web interface, select Configure>Interfaces>Ports.

    The Interfaces page lists the network interfaces present on the services gateway. Verify whether the interface has been configured by reviewing the information in the Configured column (yes/no).

  2. Select the name of the parent interface you want to edit.

    Note: You must configure the parent CT 1 or CE1 interface before you configure the child T1 or E1 interface, respectively.

  3. From the CT1/CE1 Interfaces General Configuration page, for the parent CT1 or CE1 interface, select No for the Partitioning field.
  4. Click OK to save changes.
  5. Select the name of the child interface (T1 or E1) you want to edit.
  6. To use the port on the GPIM, you must assign it to a security zone other than the Null zone. Optionally, you can also assign the port an IP address (for example, 192.168.3.1/24). Enter or select the following settings:
    1. Select Configure>Security>Zones.
    2. Add or select a security zone other than Null; for example, Trust.
    3. For host inbound traffic, set the following:
      • System Services=Allow All
      • Protocols=Allow All
    4. Click OK, and click Commit to apply the configuration and other pending changes (if any).
  7. To use the port on the GPIM, you must also set security policies. Select the following settings:
    1. Select Configure>Security>Policy>FW Policies.
    2. Set Policy Action: Default Policy Action=Permit-All.
    3. Click OK to save changes, and click Commit to apply the configuration and other pending changes (if any).

For advanced configuration information, see the Junos OS Network Interfaces Configuration Guide.

Using the CLI to Configure the CT1 Interface

To perform basic configuration for the Quad CT1/E1 GPIM (for the CT1 interface) and to configure network interfaces for the services gateway with the CLI:

Note: You must configure the parent CT1 interface before you can configure the child T1 interface.

Using the CLI to Configure the CE1 Interface

To perform basic configuration for the Quad CT1/E1 GPIM (for the CE1 interface) and to configure network interfaces for the services gateway with the CLI:

Note: You must configure the parent CE1 interface before you can configure the child E1 interface.

Related Documentation