[ Contents] [ Prev] [ Next] [ Report an Error]

MultiServices PICs (M40e Router)

Figure 21: MultiServices 100 PIC

Image g002375.gif

Figure 22: MultiServices 400 PIC

Image g002376.gif

Software release

  • MultiServices 100: JUNOS 8.1 and later (Type 1)
  • MultiServices 400: JUNOS 8.1R2 and later (Type 2)

Description

  • Supports tunnel services. This feature is included with the PIC and does not require an individual license.
  • Individual licenses must be purchased for additional services.
  • Power requirement:
    • Type 1: 0.52 A @ 48 V (25 W)
    • Type 2: 0.69 A @ 48 V (33 W)

Hardware features

  • Active monitoring on:
    • Type 1: up to 1.6 million flows
    • Type 2: up to 3.2 million flows

Software features

  • Support for up to 2000 service sets
  • Support for MTUs up to 9192 bytes for Gigabit Ethernet and SONET interfaces

Depending on your JUNOS release and individual licenses, software features for this PIC can include the features listed in Table 20. For more information about the software features available for services PICs, see the JUNOS Services Interfaces Configuration Guide.

LEDs

Status LED, one tricolor:

  • Off—PIC is offline and it is safe to remove it from the chassis.
  • Green—PIC is operating normally.
  • Amber—PIC is initializing.
  • Red—PIC has an error or failure and no further harm can be done by removing it from the chassis.

Application LED, one bicolor:

  • Off—Service is not running.
  • Green—Service is running under acceptable load.
  • Amber—Service is overloaded.

Table 20: MultiServices PICs Software Features Supported by the M40e Router

Software Feature

MultiServices 100

MultiServices 400

GRE Key

GRE dont-fragment

Stateful firewall with packet inspection: detects SYN attacks, ICMP and UDP floods, and ping-of-death attacks

8.1

8.1R2

Network Address Translation (NAT) for IP addresses

8.1

8.1R2

Port Address Translation (PAT) for port numbers

8.1

8.1R2

IP Security (IPSec) encryption

8.1

8.1R2

Active flow monitoring exports cflowd version 5 and version 8 records

8.1

8.1R2

Active flow monitoring exports flow monitoring version 9 records, based on RFC 3954

8.3

8.3

Passive flow monitoring

8.4

Passive flow collection

8.5

Flow-tap

8.1

8.1R2

Dynamic flow capture

Real-time performance monitoring

8.2

8.2

Link services

8.1

8.1R2

Tunnel services:

  • IP-IP unicast tunneling
  • GRE unicast tunneling—Supports GRE fragmentation
  • Protocol Independent Multicast (PIM) sparse mode unicast tunneling

8.1

8.1R2

Virtual tunnel interface for Layer 3 VPNs

8.1

8.1R2

Layer 2 Tunneling Protocol (L2TP)

Voice services:

  • Compressed Real-Time Transport Protocol (CRTP)

8.1

8.1R2

Encapsulations:

  • Multilink Frame Relay (MLFR)
  • Multilink Point-to-Point Protocol (MLPP)

8.1

8.1R2


[ Contents] [ Prev] [ Next] [ Report an Error]