Technical Documentation

Booting and Configuring the Junos Space JA1500 Appliance

Follow these steps to start up the Junos Space JA1500 Appliance and install the Junos Space application and operating system.

The JA1500 Appliance must be installed in a rack, turned on, and connected to a console terminal running an emulation utility such as HyperTerminal.

To start a JA1500 appliance and install the Junos Space software, follow these steps:

  1. Configure a console terminal or terminal emulation utility to use the following serial connection parameters:
    • 9600 bits per second
    • 8-bit no parity (8N1) 8
    • 1 stop bit
    • No flow control
  2. Connect the terminal to the CONSOLE port using the console cable.
  3. Plug the power cord into the AC receptacle on the rear panel. If the appliance has two power supplies, plug a power cord into each AC receptacle.
  4. Plug the other end of the power cord into a wall socket. If the appliance has two power supplies, plug each power cord into a separate wall sockets.

    The appliance is shipped with a version of the Junos Space software. When the appliance is powered on, the serial console displays diagnostic information before booting. When booting is complete, the serial console displays the login prompt. You are now ready to configure basic settings on the appliance. See Configuring Basic Settings for a Junos Space JA1500 Appliance


Published: 2010-08-09

Help
|
My Account
|
Log Out