Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Replacing the Hard Disk on a JA1500 Junos Space Appliance

    The Junos Space JA1500 appliance ships with three hard disk drives in RAID 5 array configuration. The hot-swappable drives are externally accessible in field-replaceable trays. You can remove and replace a hard disk without powering off the appliance or disrupting any functions performed by the appliance. If a hard drive fails, the Hard Disk Fault LED on the hard disk turns on and an alarm sounds.

    Figure 1: JA1500 Appliance Hard Disk Status LEDs

    JA1500 Appliance Hard
Disk Status LEDs

    Caution: RAID system performance is impacted during the hard disk recovery process. The rebuild process can take between one hour and a day depending on the system load.

    Ensure that you have the following parts and tools available to remove the hard disk from the appliance chassis:

    • (Optional) Electrostatic discharge (ESD) grounding strap
    • Flat screwdriver
    • An antistatic bag or an antistatic mat

    Removing the Hard Disk

    To remove a hard disk from the JA1500 appliance, do the following:

    1. Place the antistatic bag or antistatic mat on a flat, stable surface.
    2. (Optional) Attach an ESD grounding strap to your bare wrist, and connect the strap to an external ESD point.
    3. Loosen the hard disk captive screws, as shown in Figure 2.
    4. Gently slide the hard disk out of the slot. Keep one hand underneath the hard disk to support it while removing it from the chassis.
    5. Place the hard drive in the antistatic bag or on the antistatic mat placed on a flat, stable surface.

    Figure 2: Removing a Hard Disk

    Removing a Hard Disk

    Installing the Hard Disk

    To install a hard disk in the JA1500 appliance, do the following:

    1. (Optional) Attach an ESD grounding strap to your bare wrist, and connect the strap to an external ESD point.
    2. Remove the replacement hard disk from its antistatic bag.
    3. Slide the hard disk into the hard disk slot.
    4. Tighten and secure the two captive screws, as shown in Figure 3..
    5. Using a flat screwdriver, turn the screw clockwise to the locked position so that the notch in the screw is oriented vertically.

    Figure 3: Installing a Hard Disk

    Installing a Hard Disk

    When you install a replacement hard disk, the alarm shuts off when the new drive is sensed and the red Hard Disk Fault LED on the new hard drive starts blinking, which indicates that the drive is being rebuilt. When the drive is rebuilt, the red LED goes out.

    Modified: 2016-03-18