General Safety Guidelines and Warnings
The following guidelines help ensure your safety and protect the appliance from damage. The list of guidelines might not address all potentially hazardous situations in your working environment, so we recommend that you be alert and exercise good judgment at all times.
Perform only the procedures explicitly described in the hardware documentation for this product. Make sure that only authorized service personnel perform other system services.
Keep the area around the chassis clear and free from dust before, during, and after installation.
Keep tools away from areas where people could trip over them while walking.
Do not wear loose clothing or jewelry, such as rings, bracelets, or chains, which can get caught in the chassis.
Wear safety glasses if you are working under any conditions that could be hazardous to your eyes.
Do not perform any actions that create a potential hazard to people or make the equipment unsafe.
Never attempt to lift an object that is too heavy for one person to handle.
Never install or manipulate wiring during electrical storms.
Never install electrical jacks in wet locations unless the jacks are specifically designed for wet environments.
Operate the appliance only when it is properly grounded.
Ensure that the separate protective earthing terminal provided on this product is permanently connected to earth.
Replace fuses only with fuses of the same type and rating.
Do not open or remove chassis covers or sheet-metal parts unless instructions are provided in the hardware documentation for this product. Such an action could cause severe electrical shock.
Do not push or force any objects through any opening in the chassis frame. Such an action could result in electrical shock or fire.
Avoid spilling liquid on the appliance. Such an action could cause electrical shock or damage the appliance.
Avoid touching uninsulated electrical wires or terminals that are not disconnected from their power source. Such an action can cause electrical shock.
Always ensure that all modules, power supplies, and blanks are fully inserted and that the installation screws are fully tightened.