Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Connecting the JSA3800 Appliance to a Management Device

 

You can control the JSA3800 appliance through a connected management device (such as a laptop). Use the console port to connect your laptop as shown in Figure 1.

Figure 1: Connecting the Management Device
Connecting
the Management Device

For the location of the ports, refer to the JSA3800 Back Panel Components table in JSA3800 Appliance Back Panel Description.

Note

You can choose any GB ports as the management port.

To connect a management device with the JSA3800 appliance:

  1. Connect external devices using the ports on the back panel of the appliance.
  2. If you use a laptop, connect the laptop to the DB-9 serial console port on the back panel.
  3. Plug an Ethernet cable into the network port on the back panel.
  4. Plug a RS-232 (DB-9 F/F) cable into the console port.Note

    When using a laptop to connect to the appliance, you must use a terminal program, such as HyperTerminal, to connect to the appliance.

  5. Select the appropriate COM port to use.
  6. Configure the following port settings:
    • Bits per second = 9600

    • Stop bits = 1

    • Data bits = 8

    • Parity = None