Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Verifying Configurations and Traffic from the CLI

 

To verify interface configurations, use the following CLI commands. Refer also to the Juniper ATP Appliance CLI Command Reference for more information and to set traffic-filter and x-forwarded-for configurations:

Table 1: Configurations and Traffic CLI

CLI Mode & Command

Purpose

JATP (diagnosis)# setupcheck all

Run a check of all system components

JATP (server)# show interface

Verify interface connectivity and status

JATP (server)# show ip <interface>

Verify traffic [example: show ip eth1]

JATP (server)# ping x.x.x.x

Ping connected devices.

JATP (diagnosis)# capture-start <IP address> <interface>

Starts packet capture as a means for diagnosing and debugging network traffic and obtaining stats (not part of the Collector traffic capture engine).

JATP (server)# shutdown

Shutdown before moving a devices to a different location, or to perform server room maintenance etc

Note: Be sure to refer to the Juniper ATP Appliance CLI Command Reference for more information. Special characters used in CLI parameters must be enclosed in double quotation marks.