- Four Gigabit Ethernet ports
- Power requirement: 0.65 A @ 48 V (31 W)
- High-performance throughput on each port: speeds up to 1 Gbps
- Full-duplex mode
- Large maximum transmission units (MTUs) of up to 9192
- Intelligent handling of oversubscribed traffic
- Optical diagnostics and related alarms
- Quality of service (QoS) per channel: weighted round-robin
(WRR), random early detection (RED), weighted random early detection
- Virtual Router Redundancy Protocol (VRRP) support
- Hierarchical shaping
- Fine-grained queuing and shaping per logical interface
at both ingress and egress
- 802.1q virtual LANs (VLANs)
- VLAN stacking and rewriting
- Channels defined by two stacked VLAN tags
- Multiple tag protocol identifiers (TPID) support
- IP service for nonstandard TPID and stacked VLAN tags
- 802.1p rewrite per channel
- Flexible mapping of channels and scheduler resources at
both ingress and egress
- Flexible Ethernet encapsulation
- MAC learning, policing, accounting, and filtering
Cables and connectors
- You can install any transceiver supported by the PIC.
For information about installing and removing transceivers, see the PIC and Transceiver Installation Instructions
- Fiber-optic small form-factor pluggable transceivers (SFPs):
- Copper 1000Base-T SFPs:
- Connector: Four-pair, Category 5 shielded twisted-pair
connectivity through an RJ-45 connector
- Pinout: MDI crossover
- Length: 328 ft/100 m
OK LED, one tricolor:
- Off—PIC is offline and it is safe to remove it from
- Green—PIC is operating normally.
- Amber—PIC is initializing.
- Red—PIC has an error or failure.
APP LED, one bicolor:
- Off—Monitoring application is not running.
- Green—Monitoring application is running under acceptable
Port LEDs, one per port:
- Off—Port is not enabled.
- Green—Port is online with no alarms or failures.