[
Contents]
[
Prev]
[
Next]
[
Index]
[
Report an Error]
Unpacking an EX-series Switch
The EX-series switch is shipped in
a cardboard carton and is secured with foam packing material. The
carton also contains an accessory box.
 |
Note:
The EX-series switch is maximally protected inside the
shipping carton. Do not unpack it until you are ready to begin installation.
|
To unpack the switch (see Figure 23):
- Move the shipping carton to a staging area
as close to the installation site as possible, but where you have
enough room to remove the system components.
- Position the carton so that the arrows are pointing
up.
- Open the top flaps on the shipping carton.
- Remove the accessory box and verify the contents
against the parts inventory on the label attached to the carton.
- Pull out the packing material holding the switch
in place.
- Verify the chassis components received against
the packing list included with the switch. An inventory of parts provided
with an EX-series switch is provided in Table 27.
- Save the shipping carton and packing materials
in case you need to move or ship the switch later.
Figure 23: Unpacking an
EX-series Switch

Table 27: Inventory
of Components Provided with an EX-series Switch
Component
|
Quantity
|
Switch
|
1
|
Fan tray (pre-installed)
|
1
|
Power supply (pre-installed if the switch uses a 320 W
power supply; not pre-installed if the switch uses a 600 W or
930 W power supply)
|
1
|
Power cord retainer clip
|
1
|
Mounting brackets
|
2
|
Mounting screws
|
8
|
Rubber feet
|
4
|
RJ-45 cable
|
1
|
RJ-45 rollover cable
|
1
|
RJ-45 to DB-9 serial port adapter
|
1
|
Virtual chassis cable (for an EX 4200 switch)
|
1
|
Virtual chassis cable connector retainers (for an EX
4200 switch)
|
2
|
Related Topics
[
Contents]
[
Prev]
[
Next]
[
Index]
[
Report an Error]