Configuring Ethernet Interfaces

This chapter describes how to configure Ethernet interfaces on E Series Broadband Services Routers.

Most of the procedures described here do not apply to the Fast Ethernet management port on the SRP module. You can, however, select and display statistics for that port by using commands described in this chapter. For information about managing the Fast Ethernet port on the SRP module, see JunosE System Basics Configuration Guide.

This chapter contains the following sections:

• Ethernet Features Overview
• Ethernet Interface Platform Considerations
• Fast Ethernet I/O Modules Overview
• Gigabit Ethernet I/O Modules and IOAs Overview
• GE I/O Modules Overview
• GE-2 SFP I/O Modules Overview
• GE-8 I/O Modules Overview
• OC3-2 GE APS I/O Modules Overview
• ES2-S1 GE-4 IOAs Overview
• ES2-S1 GE-8 IOAs Overview
• ES2-S3 GE-20 IOAs Overview
• 10-Gigabit Ethernet IOAs Overview
• ES2-S1 10GE IOAs Overview
• ES2-S2 10GE PR IOAs Overview
• Ethernet References
• High-Density Ethernet Overview
• Managing Port Redundancy on Gigabit Ethernet I/O Modules
• Configuring Ethernet Interfaces
• Configuring the Physical Interface
• Disabling Ethernet Interfaces
• Setting Statistics Baselines for Ethernet Interfaces
• Monitoring the Status of Fast Ethernet Interfaces
• Monitoring the Status of Gigabit Ethernet and 10-Gigabit Ethernet Interfaces
• Monitoring the Status of MAC Address Validation on Physical Interfaces