Configuring Point-to-Point Protocol over Ethernet

This chapter describes how to configure the Point-to-Point Protocol (PPP) over Ethernet interfaces on E Series routers.

This chapter contains the following sections:

• Understanding PPPoE
• PPPoE Service Name Tables Overview
• Identification of Subscribers Using the PPPoE Remote Circuit Identifier
• PPPoE Platform Considerations
• PPPoE References
• Access Nodes in Ethernet Aggregation Networks Overview
• ATM-to-Ethernet Interworking Overview
• Configuring PPPoE over ATM
• Guidelines for Overriding the PPPoE Maximum Session Value
• Overview of IWF PPPoE Sessions with Duplicate MAC Addresses
• Guidelines for Configuring Duplicate Protection for IWF PPPoE Sessions
• Single DSLAM Connected to a PPPoE Access Concentrator
• Multiple DSLAMs Connected to a PPPoE Access Concentrator
• PPPoE with Ethernet Modules Configuration Overview
• Configuring IPv4 and IPV6 over static PPPoE with VLANs
• Configuring IPv4 over PPPoE Without VLANs
• PADM Messages Overview
• Configuring MOTM Messages from Privileged Exec Mode
• Configuring MOTM Messages from Interface Configuration Mode
• Configuring MOTM Messages from Profile Configuration Mode
• Configuring URL Messages from Interface Configuration Mode
• Configuring URL Messages from Profile Configuration Mode
• PADN Messages Overview
• Configuring PADN Messages
• Creating and Populating PPPoE Service Name Tables
• Enabling Usage of PPPoE Service Name Tables with Static Interfaces over ATM
• Enabling Usage of PPPoE Service Name Tables with Static Interfaces over Ethernet
• Enabling Usage of PPPoE Service Name Tables with Dynamic Interfaces
• Configuring PADS Packet Content
• Configuring PPPoE Remote Circuit ID Capture