Technical Documentation
Feedback
Documentation Search
Related Documentation
- Configuring Local ATM Cross-Connects with AAL5 Encapsulation, Configuring Local Cross-Connects Between Ethernet/VLAN Interfaces, Configuring the Loopback Interface and Router ID for BGP for L2VPNs, Configuring the Loopback Interface and Router ID for VPLS, and Configuring MPLS LSPs for L2VPNs in the JunosE BGP and MPLS Configuration Guide
ip address
Syntax
ip address ipAddress ipMask [ secondary ]
no ip address [ ipAddress ipMask [ secondary ] ]
Release Information
Command introduced before JunosE Release 7.1.0.
Description
Sets a primary or secondary IP address for an interface or subinterface. The no version removes an IP address or disables IP processing. You must specify the layer 2 encapsulation before you can set the IP address.
Options
- ipAddress—IP address in 32-bit dotted decimal format (for example, 192.56.32.2)
- ipMask—mask for associated IP subnet in dotted decimal or prefix length notation
- secondary—Specifies that the configured address is a secondary IP address; if omitted, the configured address is the primary IP address
Mode
Interface Configuration, Profile Configuration, Subinterface Configuration
Related Documentation
- Configuring Local ATM Cross-Connects with AAL5 Encapsulation, Configuring Local Cross-Connects Between Ethernet/VLAN Interfaces, Configuring the Loopback Interface and Router ID for BGP for L2VPNs, Configuring the Loopback Interface and Router ID for VPLS, and Configuring MPLS LSPs for L2VPNs in the JunosE BGP and MPLS Configuration Guide
Published: 2011-01-10
Copyright© 1999-2011 Juniper Networks, Inc. All rights reserved.
