JunosE 11.3.0 Release Notes

Errata

This section identifies errors found in the JunosE documentation. These errors are corrected in subsequent releases of the affected documentation.

• The Resolved Known Problems section of the JunosE 10.2.2 Release Notes failed to mention in the IP section that defect ID 90081, High CPU utilization, was fixed in that release.
• In JunosE Physical Layer Configuration Guide, the Monitoring SONET/SDH Interfaces section in Chapter 3, Configuring Unchannelized OCx/STMx Interfaces, and the Monitoring Interfaces section in Chapter 4, Configuring Channelized OCx/STMx Interfaces, for JunosE Release 9.x, Release 10.x, Release 11.0.x, Release 11.1.x, and Release 11.2.x, the field description of the "time since last status change" field is incorrectly displayed as "time since the module was rebooted" for the show controllers sonet and show controllers sonet configuration commands.

The correct field description is "time the controller has been in the current physical state" for all four instances.

• The following information was erroneously omitted from the Generating UDP Checksums in Packets to L2TP Peers section of Chapter 12, Configuring an L2TP LAC, of the JunosE Broadband Access Configuration Guide for Release 11.1.x and Release 11.2.x:

L2TP checksum generation support is available on an ES2 10G Uplink LM and an ES2 4G LM only. It is not supported on an ES2 10G LM and an ES2 10G ADV LM. If an ES2 10G LM or an ES2 10G ADV LM is present when L2TP checksum is enabled, the checksum is not calculated and its value is set to zero.