path ds3 mdl transmit

Syntax

[ no ] path pathChannel ds3 ds3Channel mdl transmit
{ path-id | idle-signal | test-signal }

Release Information

Command introduced before JunosE Release 7.1.0.

Description

Enables you to transmit an MDL message on a DS3 signal. This command applies to a DS3 over channelized SONET interface. The no version disables transmission of the specified message or all messages.

Options

• pathChannel—Number, in the range 1–2147483648, that identifies the path
• ds3Channel—Number, in the range 1–3, that identifies the path
• path-id—Transmits a path identification message every second; default value is disabled
• idle-signal—Transmits an idle signal message every second; default value is disabled
• test-signal—Transmits a test signal message every second; default value is disabled

Mode

Controller Configuration