debug ip rip

debug ip rip ripLog [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ]

no debug ip rip ripLog

Command introduced before JunosE Release 7.1.0.

Shows information about the selected variable. The no version disables the display.

ripLog—RIP log of interest; one of the following options:
- events—General RIP events, such as removing RIP from an interface or creating the RIP process
- route—Events associated with two RIP routers exchanging routes
severity—Specifies the minimum severity of the log messages displayed for the selected category; described either by a descriptive term—severityValue—or by a corresponding number—severityNumber—in the range 0–7; the lower the number, the higher the priority:
- emergency or 0—System unusable
- alert or 1—Immediate action needed
- critical or 2—Critical condition exists
- error or 3—Error condition
- warning or 4—Warning condition
- notice or 5—Normal but significant condition
- info or 6—Informational message
- debug or 7—Debug message
verbosityLevel—Verbosity of the log category's messages; can be any of the following:
- low—Terse
- medium—Moderate detail
- high—Verbose

Privileged Exec