- Download
Software
- Research a
Problem - Case Management
- Communities and Forums
- Contract & Product Management
- Technical Documentation Advanced Search
- Documentation Feedback Form
- Documentation Symbols Key
- End-of-Life Products
- Guidelines and Policies
- Security Resources
Juniper was the first North American IP routing vendor to achieve the prestigious TL 9000 certification by the Quality of Excellence for Suppliers of Telecommunications (QuEST) Forum in the router category, for design, development, provision and service and support.
What is J-Care?
It's the world-class service and support that you expect from a company that delivers the industry's best infrastructure and security products. With J-Care, you now have the confidence knowing that Juniper will do our part to keep you on top of the world!
Configuring Low-Latency Mode for Per-Port Queuing on ATM Interfaces
In low-latency mode, the SAR scheduler backpressures the HRR scheduler per physical port; each physical port buffers only a few kilobytes.
When you configure low-latency mode:
- VC backpressure is disabled.
- Port backpressure is enabled as aggressive.
- SAR scheduler performs minimal buffering.
- HRR scheduler is dominant.
This procedure creates the low-latency mode configuration shown in Figure 1.
Figure 1: Low-Latency Mode
To configure low-latency mode with a strict-priority queue and a best-effort queue:
- Configure the traffic class.host1(config)#traffic-class strict host1(config-traffic-class)#exit
- Set the traffic class in the traffic-class group. host1(config)#traffic-class-group strict host1(config-traffic-class-group)#traffic-class strict host1(config-traffic-class-group)#exit
- Define the scheduler profile for the traffic-class group.host1(config)#scheduler-profile strict host1(config-scheduler-profile)#strict-priority host1(config-scheduler-profile)#exit
- Configure the QoS profile with two ATM VC queues.host1(config)#qos-profile low-latency-q-p host1(config-qos-profile)#atm-vc node host1(config-qos-profile)#atm-vc queue traffic-class best-effort host1(config-qos-profile)#atm group strict scheduler-profile strict host1(config-qos-profile)#atm-vc queue traffic-class strict host1(config-qos-profile)#exit
- From the desired port, set the QoS port mode to low latency.host1(config)#interface atm 2/0 host1(config-if)#qos-mode-port low-latency host1(config-if)#qos-profile low-latency-q-p
Tip: For ATM interfaces on ERX7xx models, ERX14xx models, and the ERX310 router, you must specify port 0.
The qos-mode-port command:
- Excludes non-UBR ATM QoS services on any VC on the ATM module; for example, PCR, nrtVBR, and CBR
- Cannot be used if shaping is currently configured on the SAR scheduler
- Cannot be used with ATM VP tunnels with nonzero rates; however, can be used with tunnels with rates of zero (shapeless tunnels).
