Resolved Known Problems
Release 11.0.0 is based on Release 10.3.0 and incorporates all problem resolutions found in that release. The following problems were reported open in Release 10.3.0 and have been resolved in this release, or have been resolved since the 10.3.0 release. For more information about particular resolved problems, you can log in to the JUNOSe Knowledge Base at https://www2.juniper.net/kb/, enter the defect ID number in the Search by Keyword field, and click Search.
Ethernet
- When you remove the IP address of a LAG bundle on an ES2 10G LM or an ES2 10G ADV LM, which is configured with a Gigabit Ethernet physical interface as the member interface and assigned an IP address and subnet mask, the line module resets during the time of deletion of the IP address. This problem occurs if you enabled a VRRP instance identifier (VRID), assigned an IP address with the VRID, and configured the VRRP advertisement interval time for the LAG bundle. [Defect ID 181116]
IPv6
- When an IPv6 client that is connected to the requesting router using a PPP link is delegated a prefix by the DHCPv6 server, the client binding is not removed when the PPP session terminates and is retained until the lease time expires. As a result, when the same PPP client logs in again and sends a DHCPv6 SOLICIT request to the DHCPv6 server, the SOLICIT request is ignored if the prefix or the local address pool returned by the RADIUS server is different from the prefix or pool that was returned by the RADIUS server for the previous login session, and the existing binding is retained untouched. If RADIUS returns the same prefix or pool information as the previous login session, the DHCPv6 advertise message is returned to the client. This behavior is expected and occurs because the DHCPv6 server does not create a new client binding until the old binding is removed when the lease time expires. [Defect 182020]
L2TP
- L2TP over MPLS is not supported for the ES2 10G ADV LM. L2TP over MPLS is supported for the ES2 4G LM, ES2 10G Uplink LM, and ES2 10G LM in all possible module combinations. [Defect ID 85608]
Multicast