GE2 1000Base-LH Module Combination (2 Ports)

Line module label	GE-2
I/O module label	GE-2 SFP I/O or 2XGE APS I/O SFP or GE-2 APS I/O SFP
Number of I/O ports	2 active, 2 redundant
Software release	First supported: 5.3.0 Final supported: Not applicable
Description	100 W Gigabit Ethernet The I/O module uses a range of small form-factor pluggable (SFP) transceivers to support different modes and cabling distances. Uses either optical or copper SFPs. The optical transceivers are 1000Base-LX/LH compliant. The copper transceivers are 1000Base-T compliant. For information about bandwidth and line rate considerations for the GE2 1000Base-LH module combination, see GE–2 SFP I/O Module in JUNOSe Physical Layer Configuration Guide, Chapter 5, Configuring Ethernet Interfaces.
Type	ASIC
Capability	Ethernet (IEEE 802.3z) 1000Base-LH
Software features	See Ethernet Modules for information about the layer 2 and layer 3 protocols and applications that this module combination supports.
Model compatibility	ERX-1440 router ERX-310 router
SRP module compatibility	SRP-40G SRP-40G PLUS SRP-SE10G
Module redundancy support	Not applicable
Cables and connectors (copper SFP)	Maximum range is 100 meters on CAT5 cable.
Cables and connectors (LX/LH)	LC full duplex Tx power: min: –9.5 dBm max: –3 dBm Center wavelength: 1300 nm Rx input power: min: –20 dBm max: –3 dBm Rated for 10 km (6.2 miles) over 9-micron core cable See ERX Hardware Guide, Chapter 5, Cabling ERX Routers for more information.
Cables and connectors (single–mode LX40)	LC full duplex Tx power: min: –4.5 dBm max: 0 dBm Center wavelength: 1300 nm Rx input power: min: –35 dBm max: –22.5 dBm Rated for 40 km (24.85 miles) over 9-micron core cable See ERX Hardware Guide, Chapter 5, Cabling ERX Routers for more information.
LEDs	See Module LEDs.
Alarms, errors, and events	See Monitoring Ethernet Interfaces in JUNOSe Physical Layer Configuration Guide, Chapter 5, Configuring Ethernet Interfaces.