Before You Configure IPv6
Before you configure IPv6, you must create the lower-layer interfaces over which IPv6 traffic flows. In this release, the following modules support IPv6 configuration:
- ATM OC3/STM-1
- ATM OC12/STM-4
- Fast Ethernet (FE-8)
- Gigabit Ethernet (GE)
- 10-Gigabit Ethernet (10GE)
- OC48 POS (PPP only)
For example, to configure an ATM interface:
host1(config)#interface atm 1/0 host1(config-if)#atm sonet stm-1 host1(config-if)#no loopback host1(config-if)#atm clock internal chassis host1(config-if)#interface atm 1/0.10 host1(config-if)#atm pvc 10 0 20 aal5snap
See JUNOSe Link Layer Configuration Guide for information about configuring an ATM interface. See JUNOSe Physical Layer Configuration Guide for information about configuring an Ethernet interface.
