Verifying Switching Mode Configuration on J Series uPIMs

The operational mode command for checking the status and statistics for multiport uPIMs in switching mode is different from that in routing mode. For uPIMs in routing mode, the operational commands are the same as for other Gigabit Ethernet interfaces, such as the 1-port Gigabit Ethernet ePIM and built-in Gigabit Ethernet ports.

However, not all operational mode commands are supported for ports of a uPIM in switching mode. For example, the operational mode command for monitoring port statistics is not supported.

Before You Begin
See Configuring Switching Modes on J Series uPIMs.

Note: To clear the statistics for the individual switch ports, use the clear interfaces statistics ge-pim/0/0 switch-port port-number command.

To verify the status and view statistics for a port on a uPIM in switching mode:

user@host# show interfaces ge-slot/0/0 switch-port port-number

Port 0, Physical link is Up
       	Speed: 100mbps, Auto-negotiation: Enabled       
			Statistics:                          Receive         Transmit
	         Total bytes                       28437086         21792250
	         Total packets                       409145            88008
	         Unicast packets                       9987            83817
	         Multicast packets                   145002                0
	         Broadcast packets                   254156             4191
	         Multiple collisions                     23               10
	         FIFO/CRC/Align errors                    0                0
	         MAC pause frames                         0                0
	         Oversized frames                         0
	         Runt frames                              0
	         Jabber frames                            0
	         Fragment frames                          0
	         Discarded frames                         0
	       Autonegotiation information:
	         Negotiation status: Complete
	         Link partner:
	             Link mode: Full-duplex, Flow control: None, Remote fault: OK, Link partner Speed: 100 Mbps
	         Local resolution:
	             Flow control: None, Remote fault: Link OK