Software release
- JUNOS 4.0 and later
Description
- One OC12 port
- Power requirement: 0.23 A @ 48 V (10.8 W)
- 12 DS3 channels
- Supports IP version 4 (IPv4) unicast and multicast as well as MPLS, Intermediate System-to-Intermediate System (IS-IS), Open Shortest Path First (OSPF), and Border Gateway Protocol (BGP)
Hardware features
- ASIC-based, high-performance throughput on all ports
- Integrated DSU functionality with subrate and scrambling support for each DS3 channel
- Class-of-service support for each DS3 channel
- Dual-router SONET automatic protection switching (APS)
- Rate policing on input for each DS3 channel
- Rate shaping output for each DS3 channel
- Packet buffering, Layer 2 parsing
Software features
- M13/C-bit parity encoding
- Full instrumentation per DS3 channel
- DS3 diagnostics and loopback control
- DS3 alarm and event counting and detection
- DS3 Far-end Alarm and Control (FEAC) channel support
- Encapsulations:
- High-level Data Link Control (HDLC)
- Frame Relay
- Multiprotocol Label Switching (MPLS) circuit cross-connect (CCC) and translational cross-connect (TCC)
- Point-to-Point Protocol (PPP)
Cables and connectors
- Duplex SC/PC connector (RX and TX); single-mode fiber
LEDs One tricolor per port:
- Off—Not enabled
- Green—Online with no alarms or failures
- Amber—Online with alarms for remote failures
- Red—Active with a local alarm; router has detected a failure
Alarms, errors, and events
- Alarm Indication Signal (AIS-L, AIS-P)
- BERT functionality (you can configure one DS3 channel in BERT mode and configure the remaining channels to transmit and receive normal traffic)
- Bit Error Rate Signal Degrade (BERR-SD), Bit Error Rate Signal Fail (BERR-SF)
- Bit Interleaved Parity Errors B1, B2, B3 (CV-S, CV-L, CV-P)
- Equipment failure (Does not affect service)
- Errored Seconds (ES-S, ES-L, ES-P), Far-end Bit Errors REI-L, REI-P (CV-LFE, CV-PFE), Far-end Block Error (FEBE), Far-end Errored Seconds (ES-LFE, ES-PFE), Far-end Severely Errored Seconds (SES-LFE, SES-PFE), Far-end Unavailable Seconds (UAS-LFE, UAS-PFE)
- Frame error
- Idle code, Idle received
- Loss of Frame (LoF), Loss of Pointer (LoP-P), Loss of Signal (LoS)
- Out of Frame (OoF)
- Payload Mismatch (PLM-P), Payload Unequipped (UNEQ-P)
- Parity bit (P-bit) disagreements
- Path parity error
- Remote Defect Indication (RDI-L, RDI-P)
- Severely Errored Framing (SEF), Severely Errored Framing Seconds (SEFS-S), Severely Errored Seconds (SES-S, SES-L, SES-P), Unavailable Seconds (UAS-L, UAS-P)
- Yellow alarm bit (X-bit) disagreements
Table 4: Optical Interface Support for Channelized OC12 PICs
