Gigabit Ethernet PIC

Software release

JUNOS 3.2 and later

Description	One Gigabit Ethernet port Power requirement: Supports large Ethernet frame sizes for more efficient throughput across the intra-POP network
Hardware features	High-performance throughput on all ports at speeds up to 1 Gbps Autonegotiation between Gigabit Ethernet circuit partners Full-duplex mode Maximum transmission units (MTUs) of up to 9192 bytes
Software features	Virtual Router Redundancy Protocol (VRRP) support 802.1Q virtual LANs (VLANs) support 64 source MAC address filters per port 960 destination MAC filters per port
Cables and connectors	Duplex SC connector (TX and RX) Optical interface support—see Table 4
LEDs	Status LEDs, one bicolor: Off—PIC not enabled Green—PIC is operating normally Red—PIC has an error or failure Port LEDs, one pair per port: Link—If green, the port is online; if there is no light, the port is down Activity—If flashing green, the port is receiving data; if there is no light, the port might be on, but is not receiving data

Table 4: Optical Interface Support for Gigabit Ethernet PICs

PIC Type	SX Transceiver	LX Transceiver	LH Transceiver
Optical interface	656 ft/200 m reach on 62.5/125 micrometer multimode fiber (MMF) 1640 ft/500 m reach on 50/125 micrometer MMF	6.2 miles/10 km reach on 9/125 micrometer single-mode fiber (SMF) 1804.5 ft/550 m reach on 62.5/125 and 50/125 micrometer MMF	43.5 miles/70 km reach on 9/125 micrometer SMF
Wavelength	830 through 860 nm	1270 through 1355 nm	1480 through 1580 nm
Average launch power	–9.5 through –4 dBm	–11 through –3 dBm	–3 through +2 dBm
Receiver saturation	–3 dBm	–3 dBm	–3 dBm
Receiver sensitivity	–17 dBm	–19 dBm	–23 dBm (BER 1012) for SMF