Installing a Routing Engine

Note: If two Routing Engines are installed, they must both be the same version.

To install a Routing Engine, follow this procedure (see Figure 79):

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. Verify that the router is attached to a proper earth ground. For more information about ESD, see Preventing Electrostatic Discharge Damage.
2. Verify that the extractor clip at each end of the Routing Engine is flipped toward the outer edge of the unit. If necessary, use your thumbs to push and hold the red tab on each extractor clip toward the outer edge, then push the ends of the extractor clips outward.
3. Place one hand under the Routing Engine to support it and grasp one of the extractor clips on the faceplate with the other hand.
4. Align the rear of the Routing Engine with the guide rails inside the chassis and slide it in completely.

   Caution: Align the Routing Engine carefully with the guide rails and push it in evenly. Damage can result if the Routing Engine gets lodged in the rails because of uneven movement.

5. Press the extractor clip at each end of the Routing Engine inward to seat the unit firmly in the chassis.
6. Check the Routing Engine LEDs on the Routing Engine panel or craft interface to verify that the green LED labeled ONLINE is lit (Figure 15 shows the LEDs).

   You can also verify correct Routing Engine functioning by issuing the show chassis routing-engine command described in Maintaining the Routing Engines.

Figure 79: Installing a Routing Engine