[Contents] [Prev] [Next] [Report an Error]

10-Gigabit Ethernet PIC

Image g001833.gif

Software release
  • JUNOS 5.3 and later
Description
  • One 10-Gigabit Ethernet port
  • Power requirement: 0.74 A/48 V @ 35.5 W
  • Supports large Ethernet frame sizes for more efficient throughput across the intra-POP network
  • Optical interface support—see Table 10
Hardware features
  • High-performance throughput at speeds up to 10 Gbps
  • Full-duplex mode
  • Maximum transmission units (MTUs) up to 9192 bytes
  • 64 source MAC address filters
  • 960 destination MAC filters
Software features
  • Virtual Router Redundancy Protocol (VRRP) support
  • 802.1Q Virtual LANs (VLANs) support
  • 802.3ae link aggregation support
  • RMON EtherStats
Cables and connectors
  • Duplex SC/PC connector (RX and TX)
LEDs Status LEDs, one bicolor:
  • Off—PIC not enabled
  • Green—PIC is operating normally
  • Red—PIC has an error or failure

Port LEDs, one pair:
  • Link—If green, the port is online; if there is no light, the port is down
  • RX—If flashing green, the port is receiving data; if there is no light, the port might be on, but is not receiving data

Table 10: Optical Interface Support for 10-Gigabit Ethernet PICs

Optical interface 6.2-mile/10-km reach on micrometer single-mode fiber (SMF) with SC/PC duplex connector
Wavelength 1260 through 1355 nm
Average launch power –4 through 0.5 dBm
Receiver saturation 0.5 dBm
Receiver sensitivity –10.3 dBm
[Contents] [Prev] [Next] [Report an Error]