Software release
- JUNOS 5.3 and later
Description
- High-bandwidth encryption (in accordance with IPSec standards)
- Power requirement: 0.21 A/48 V @ 10 W
- Support for IPSec encryption, decryption, and key calculation acceleration
Note: The ES PIC does not support reassembly and decryption of encrypted packets that were fragmented in an IPSec tunnel.
Hardware features
- Extends the existing security functionality to Internet traffic at high-performance rates
- Throughput at 800 Mbps, half duplex
- 1000 IPSec tunnels or 2000 IPSec security association (SA) pairs
- Supports MTUs of up to 3900 bytes
Software features
- Support for IPv4
- Authentication hash algorithms: MD-5 and SHA-1
- Encryption algorithms: DES, 3-DES, and Null
- Automated key management using Diffie-Hellman key establishment
- Support for pre-shared key management
- Authentication Header and Encapsulating Security Payload (ESP) independently or in bundle mode
- Tunnel mode IPSec encryption and decryption for data traffic
- Transport mode IPSec encryption and decryption for control traffic
- Static and dynamic security associations (SA) supported
- SA lifetime configurable in seconds and kilobytes
Note: Extended support for graceful Routing Engine switchover (GRES) has been added for this PIC. To configure GRES, you must be running JUNOS release 7.3 or later.
LEDs One tricolor:
- Off—Not enabled
- Green—Online with no alarms or failures
- Amber—Online with alarms for remote failures
- Red—Active with a local alarm; router has detected a failure
Instrumentation (counters)
- Input and output bytes per tunnel
- Total authentication failures
- Total anti-reply failures
- Total encryption ASIC errors per PIC
