Packing the Routing Node for Shipment

To pack the router for shipment, follow this procedure:

1. Retrieve the shipping crate and packing materials in which the router was originally shipped. If you do not have these materials, contact your Juniper Networks representative about approved packaging materials.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. Make sure the router is attached to a proper earth ground. For more information about ESD, see Preventing Electrostatic Discharge Damage.
3. On the console or other management device connected to the master Routing Engine, enter CLI operational mode and issue the following command to shut down the router software. (If two Routing Engines are installed, also issue the command on the backup Routing Engine.)
   user@host> request system halt

   Wait until a message appears on the console confirming that the operating system has halted.

   For more information about the command, see the JUNOS Protocols, Class of Service, and System Basics Command Reference.

4. Shut down power to the router by pressing the power switch for all power supplies to the off (O) position. The switches are on the circuit breaker box.
5. Disconnect power from the router. For instructions, see Disconnecting and Connecting Power.
6. Remove the cables that connect to all external devices. For instructions, see Replacing the Management Ethernet Cable, Replacing the Console or Auxiliary Cable, Replace Alarm Relay Wires, and Replace PIC Cables.
7. Remove all Field Replaceable Units (FRUs) from the router.
8. Remove the router from the rack:
   • If you are using a mechanical lift, place the lift platform under the router, unscrew and remove the mounting screws from the rack, and move the router to the shipping crate.
   • If you are not using a mechanical lift and the router weight is fully supported by a shelf or another router, unscrew and remove the mounting screws from the rack. Four people can then lift the router and move it to the shipping crate.
   • If you are not using a mechanical lift and the router weight is not fully supported by a shelf, four people should grasp the router while a fifth person unscrews and removes the mounting screws from the rack. The four lifters can then move the router to the shipping crate.
9. Place the router in the shipping crate or onto the pallet. If on a pallet, bolt the router to the pallet.
10. Cover the router with an ESD bag and place the packing foam on top of and around the router.
11. Replace the accessory box on top of the packing foam.
12. Securely tape the box closed or place the crate cover over the router.
13. Write the RMA number on the exterior of the box to ensure proper tracking.