[Contents] [Prev] [Next] [Index] [Report an Error]

Tools and Parts Required

To replace hardware components, you need the tools and parts listed in Table 24.

Table 24: Tools and Parts Required

Tool or part	Components
Electrostatic bag or antistatic mat	CIP Craft interface FPC Front impeller assembly MCS PIC PCG Routing Engine SFM
Electrostatic discharge (ESD) grounding wrist strap	All
Flat-blade (–) screwdriver, 2.5 mm	Alarm relay contacts on CIP
Flat-blade screwdriver, approximately 1/4 in. (6 mm)	Craft interface Front impeller assembly
Phillips (+) screwdrivers, numbers 1 and 2	Air filter CIP Circuit breaker box Craft interface DC power cables (to remove protective shield over circuit breaker box) Fan tray Fuse (to remove rear lower impeller assembly) Impeller assembly PCG PIC Power supply Routing Engine SFM
7/16-in. hexagonal-head external drive socket wrench, or nut driver, with a minimum of 30 lb-in. (3.5 Nm) tightening torque (See following note.)	Circuit breaker box (to remove or install power cables) DC power cables
Wire cutters	Alarm relay contacts on CIP
Rubber safety cap	Fiber-optic PIC or PIC cable

Do not substitute a metric nut driver or wrench. A tool that does not fit the nuts exactly can damage them. If a 7/16-in. tool is not available, use pliers or an adjustable wrench.

[Contents] [Prev] [Next] [Index] [Report an Error]