Removing the SFMs

The router can have an SFM in each of the slots labeled SFM 0 through SFM 3 at the rear of the chassis, as shown in Figure 3. Each SFM weighs approximately 5 lb (2.3 kg).

To remove an SFM, follow this procedure (see Figure 33):

1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. Make sure the router is attached to a proper earth ground. For more information about ESD, see Preventing Electrostatic Discharge Damage.
3. Loosen the thumbscrew on each ejector locking tab (shown in Figure 8), using a Phillips screwdriver if necessary.
4. Pull the end of each ejector handle outward until it is nearly perpendicular to the SFM faceplate.
5. Grasp the ejector handles and pull firmly to slide the SFM about halfway out of the chassis.
6. Place one hand under the SFM to support it, slide it completely out of the chassis, and place it on the antistatic mat or in the electrostatic bag.

   When an SFM is out of the chassis, do not hold it by the ejector handles. They cannot support its weight. Do not stack SFMs on top of or under other components. Place each one individually in an electrostatic bag or on its own antistatic mat on a flat, stable surface.

If additional SFMs are installed, repeat the procedure to remove them.