Connecting the SRX210 Services Gateway to the Power Supply
To connect the device to the power supply:
 | Caution: Before connecting the device to the power supply, attach an ESD strap to an ESD point and place the other end of the strap around your bare wrist. |
 | Note: If you are installing your services gateway on a desk, ensure that your device is adequately grounded using the grounding point on the back panel of the chassis. |
- Plug the DC connector end of the power cable into the power connector on the back of the device (see Figure 1).
- Plug the AC adapter end of the power cable into
an AC power outlet.
Figure 1: Connecting the SRX210 Services Gateway to the Power Supply
| Note: The device must be connected to earth ground during normal operation. The protective earthing terminal on the rear of the chassis is provided to connect the device to ground. |
| Caution: We recommend using a surge protector for the power connection. |
| Note: Use the cable tie holder to secure the power cord on to the power supply point. |
| Note: We strongly recommend that you use only the 3-pin power cord supplied with your services gateway. If you are using a 2-pin power cord, then ensure that your device is adequately grounded using the grounding point available on back panel of chassis. |
