• Supported Platforms
• JCS 1200

• Related Topics
• Preventing Electrostatic Discharge Damage to the JCS1200 Platform
• Removing a JCS1200 Switch Module Filler Tray

Installing a JCS1200 Switch Module Filler Tray

To install a switch module filler tray:

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
2. Remove the switch module filler and filler tray, if one is installed (see Removing a JCS1200 Switch Module or Module Filler and Removing a JCS1200 Switch Module Filler Tray).
3. Make sure that the release handle is in the open position.
4. Slide the switch module filler tray into the switch module bay until it stops.
5. Push the filler tray release handle to the closed position.
6. Install a switch module or filler (see Installing a JCS1200 Switch Module or Module Filler).