• Downloads
• Removing an SRX5600 Services Gateway SFP or XFP Transceiver    

• Related Topics
• Preventing Electrostatic Discharge Damage to the SRX5600 Services Gateway
• Installing an SRX5600 Services Gateway SFP or XFP Transceiver

Removing an SRX5600 Services Gateway SFP or XFP Transceiver

Small form-factor pluggable (SFPs) and XFPs are optical transceivers that are installed in an IOC. SPC, or port module. SFPs and XFPs are hot-insertable and hot-removable. Removing an SFP or XFP does not interrupt the functioning of the card, but the removed SFP or XFP no longer receives or transmits data.

To remove an SFP or XFP transceiver (see Figure 1):

1. Have ready a replacement transceiver or a transceiver slot plug, an antistatic mat, and a rubber safety cap for the transceiver.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
3. Label the cables connected to the transceiver so that you can reconnect them correctly later.

   Warning: Do not look directly into a fiber-optic transceiver or into the ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a transceiver emit laser light that can damage your eyes.

4. Remove the cable connector from the transceiver.
5. Carefully arrange the disconnected cable in the cable manager to prevent the cable from developing stress points.

   Caution: Avoid bending fiber-optic cable beyond its minimum bend radius. An arc smaller than a few inches in diameter can damage the cable and cause problems that are difficult to diagnose.

6. Pull the ejector handle out from the transceiver to unlock the transceiver.

   Caution: Make sure that you open the ejector handle completely until you hear it click. This prevents damage to the transceiver.

   Use needlenose pliers to pull the ejector handle out from the transceiver.

7. Grasp the transceiver ejector handle and pull the transceiver approximately 0.5 in. (1.3 cm) out of the card.
8. Using your fingers, grasp the body of the transceiver and pull it the rest of the way out of the card.

   Figure 1: Removing SFPs or XFPs

   

9. Place a rubber safety cap over the transceiver.
10. Place the removed transceiver on an antistatic mat or in an electrostatic bag.

Caution: After removing a transceiver from the card, wait at least 30 seconds before reinserting it or inserting a transceiver into a different socket.