Replacing an MX80 SFP or XFP Transceiver
Small form-factor pluggable transceivers (SFPs) and 10-gigabit small form-factor pluggables (XFPs) are optical transceivers that are installed in a MIC. SFPs and XFPs are hot-insertable and hot-removable.
Removing an MX80 SFP or XFP Transceiver
Removing an SFP or XFP does not interrupt MIC functioning, but the removed SFP or XFP no longer receives or transmits data.
To remove an SFP or XFP transceiver (see Figure 1):
- Have ready a replacement transceiver or a transceiver slot plug, an antistatic mat, and a rubber safety cap for the transceiver.
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Label the cables connected to the transceiver
so that you can reconnect them correctly later.
Warning: Do not look directly into a fiber-optic transceiver or into the ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a transceiver emit laser light that can damage your eyes.
- Remove the cable connector from the transceiver.
- Pull the ejector handle out from the transceiver
to unlock the transceiver.
Caution: Make sure that you open the ejector handle completely until you hear it click. This prevents damage to the transceiver.
Use needlenose pliers to pull the ejector handle out from the transceiver.
- Grasp the transceiver ejector handle, and pull the transceiver approximately 0.5 in. (1.3 cm) out of the MIC.
- Using your fingers, grasp the body of the transceiver,
and pull it the rest of the way out of the MIC.
Figure 1: Removing SFPs or XFPs
- Place a rubber safety cap over the transceiver.
- Place the removed transceiver on an antistatic mat or in an electrostatic bag.
| Caution: After removing a transceiver from the chassis, wait at least 30 seconds before reinserting it or inserting a transceiver into a different slot. |
Installing an MX80 SFP or XFP Transceiver
To install an SFP or XFP:
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Take each transceiver to be installed out of its electrostatic bag, and identify the slot on the component where it will be installed.
- Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the transceiver with a safety cap.
- Carefully align the transceiver with the slots in the component. The connectors should face the component.
- Slide the transceiver until the connector is seated in the component slot. If you are unable to fully insert the transceiver, make sure the connector is facing the right way.
- Close the ejector handle of the transceiver.
- Remove the rubber safety cap from the transceiver
and the end of the cable. Insert the cable into the transceiver.
Warning: Do not look directly into a fiber-optic transceiver or into the ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a transceiver emit laser light that can damage your eyes.
- Verify that the status LEDs on the component faceplate indicate that the SFP or XFP is functioning correctly. For more information about the component LEDs, see the MX Series 3D Universal Edge Routers Line Card Guide.
