• Downloads
• Installing the SRX210 Services Gateway on a Wall    

• Related Topics
• SRX210 Services Gateway General Safety Guidelines and Warnings
• Required Tools and Parts for Installing and Maintaining the SRX210 Services Gateway
• Preparing the SRX210 Services Gateway for Rack-Mount Installation
• Adjusting the Power Supply Adapter Tray for the SRX210 Services Gateway for Rack-Mount Installation
• Installing the SRX210 Services Gateway on a Desk
• Installing the SRX210 Services Gateway on a Wall

Installing the SRX210 Services Gateway on a Wall

You can install the SRX210 Services Gateway on a wall.

Note: The wall-mounting kit is not shipped with the device and must be ordered separately.

To install the device on a wall:

1. Place the device on a flat and level surface with Juniper Networks logo embossed on the top cover facing up. Ensure that rubber feet are attached to the bottom of the chassis.
2. Position a mounting bracket on each side of the chassis as shown in Figure 1.

   Figure 1: SRX210 Services Gateway Wall Installation — Attaching Mounting Brackets

   

   Table 1 lists the parts used for installing the SRX210 Services Gateway on a wall. The numbers in Figure 1 correspond to the numbers in Table 1.

   Table 1: SRX210 Services Gateway Wall Installation Parts

   Numbers	Part
   1	Mounting brackets
   2	Screws (mounting bracket)

3. Use a number-1 Phillips screwdriver to install the screws that secure the mounting brackets to the chassis.
4. If you are using wall anchors to support the chassis, install two pairs of anchors on the wall with the mounting brackets attached.
5. Have one person grasp the sides of the device, lift it, and position it on the wall.
6. Have a second person install two pairs of mounting screws through the bracket holes on either side of the device to secure it to the wall.
7. Verify that the mounting screws on one side are aligned with the mounting screws on the opposite side and that the device is level (see Figure 2).