Replacing an M10i Ethernet Management Cable
The MGMT port on the Routing Engine accepts Ethernet cable with and RJ-45 connector. For cable specifications, see Routing Engine Interface Cable and Wire Specifications for M10i Routers:
Figure 1: Routing Engine Ethernet Cable Connector
Figure 2: Ethernet Management Port
Removing a Management Ethernet Cable
- Press the tab on the connector and pull the connector straight out of the port. Figure 1 shows the connector.
- Disconnect the cable from the network device.
Installing a Management Ethernet Cable
- Plug one end of the replacement Ethernet cable into the MGMT port. Figure 2 shows the ports on the routing engine.
- Plug the other end of the cable into the network device.
