• Supported Platforms
• M10i Routers

• Related Topics
• Preventing Electrostatic Discharge Damage to an M10i Router
• M10i Routing Engine Architecture Overview
• Maintaining the M10i Routing Engine
• Troubleshooting the M10i Routing Engine
• Removing the M10i Routing Engine

Installing the M10i Routing Engine

To install a Routing Engine (see Figure 1):

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
2. Place one hand under the Routing Engine to support it and grasp the handle on the faceplate with the other hand.
3. Align the rear of the Routing Engine with the guide rails inside the chassis and slide it in completely.

   Caution: Align the Routing Engine carefully with the guide rails and push it in evenly. Damage can result if the Routing Engine gets lodged in the rails because of uneven movement.

4. Tighten the thumbscrews on the Routing Engine faceplate to secure the Routing Engine.

   The Routing Engine might require several minutes to boot.

5. After the Routing Engine boots, issue the show chassis routing-engine command to verify correct Routing Engine functioning.