• Supported Platforms
• M10i Routers

• Related Topics
• Preventing Electrostatic Discharge Damage to an M10i Router
• M10i Routing Engine Architecture Overview
• Maintaining the M10i Routing Engine
• Troubleshooting the M10i Routing Engine
• Installing an SDRAM Module in an M10i Routing Engine

Removing an SDRAM Module from an M10i Routing Engine

The SDRAM modules are located on the top of the Routing Engine. To remove a SDRAM module:

1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
3. Remove the Routing Engine as described in Replacing the M10i Routing Engine.
4. To release the SDRAM module, press the plastic ejectors on both sides of the module.
5. Grasp the SDRAM module, being careful not to touch any electrical components on the module, and firmly pull it out of the slot on the Routing Engine.
6. Place the SDRAM module on the antistatic mat or in the electrostatic bag.
7. Push the plastic ejectors to close the empty SDRAM module slot.