Removing the T320 Router Installation Handle and Reinstalling the Power Supplies
After you have installed the T320 router, remove the installation handle and reinstall the two power supplies in the chassis by following this procedure, starting with the lower power supply (see Figure 1):
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to an M Series, MX Series, or T Series Router.
- Loosen the captive screws on the installation handle completely, and remove the handle from the chassis.
- Make sure that the circuit breaker on the power supply faceplate is in the off position (O).
- Using both hands, slide the power supply into the chassis until you feel resistance.
- Twist the ejector handles at the upper corners of the power supply faceplate clockwise until they stop.
- Tighten the captive screws at the lower corners of the power supply faceplate to secure the power supply in the chassis.
- Repeat the procedure for the upper power supply.
Figure 1: Reinstalling a Power Supply
