Replacing the T640 Cable Restraint on a Three-Input 240-A DC Power Supply
Each three-input 240-A DC power supply is shipped with the standard cable restraint, as shown in Standard Cable Restraint on a Three-Input 240-A Power Supply. Two optional cable restraints are shipped in the accessory box.
If your DC power cables are too large or inflexible to fit into the standard cable restraint, we recommend that you remove the standard cable restraint and install the optional cable restraint (see Optional Cable Restraint on a Three-Input 240-A Power Supply) on each three-input 240-A DC power supply.
 | Note: Before you remove a chassis from a rack or cabinet, you must remove the optional cable restraint from the three-input 240-A DC power supply. |
To replace the cable restraint on a three-input 240-A DC power supply, perform the following tasks:
Removing the T640 Standard Cable Restraint from a Three-Input 240-A DC Power Supply
The cable restraint is located on the right edge of the power supply faceplate. To remove the standard cable restraint from a three-input 240-A DC power supply:
- Loosen the captive screw on the standard cable restraint or captive screws on the optional cable restraint.
- Remove the cable restraint from the power supply.
Figure 1: Standard Cable Restraint on a Three-Input 240-A DC Power Supply
Installing the T640 Optional Cable Restraint on a Three-Input 240-A DC Power Supply
To install the optional cable restraint on a three-input 240-A DC power supply:
- Align the two captive screws on the optional cable restraint with the two threaded holes located at the right edge of the power supply faceplate.
- Fasten the captive screws.
Figure 2: Optional Cable Restraint on a Three-Input 240-A DC Power Supply
