Installing a T1600 Three-Input 240-A DC Power Supply
Each three-input 240-A DC power supply weighs approximately 25 lb (11.3 kg). To install a three-input 240-A DC power supply:
- Make sure that the voltage across the DC power source cable leads is 0 V and that there is no chance that the cables might become active during installation.
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Switch the circuit breakers on the power supply faceplate to the OFF position (O).
- Using both hands, slide the power supply into the chassis until you feel resistance (see Figure 1).
- Twist the ejector handles at the upper corners of the power supply faceplate clockwise until they stop.
- Tighten the captive screws at the lower corners of the power supply faceplate to secure the power supply in the chassis.
Figure 1: Installing a Three-Input 240-A Power Supply
