Removing an SRX5600 Services Gateway AC Power Supply
The power supplies are located at the rear of the chassis. Each AC power supply weighs approximately 5.0 lb (2.3 kg).
 |
Caution: Do not leave a power supply slot empty for more than 30 minutes while the services gateway is operational. For proper airflow, the power supply must remain in the chassis, or a blank panel must be used in an empty slot. |
 |
Note: After powering off a power supply, wait at least 60 seconds before turning it back on. |
To remove an AC power supply (see Figure 1):
- Switch off the dedicated facility circuit breaker for the power supply, and remove the power cord from the AC power source. Follow the ESD and disconnection instructions for your site.
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Move the AC switch next to the appliance inlet on the power supply to the off position (O).
- Unscrew the captive screws on the bottom edge of the power supply.
- Remove the power cord from the power supply.
- Pull the power supply straight out of the chassis.
Figure 1: Removing an AC Power Supply
