• Download Software
• Research a Problem 
• Case Management 
• Contract & Product Management 
• Technical Documentation
  • Advanced Search
  • Documentation Archive
  • Documentation Bug Report
  • Enterprise MIBs
  • File Format Help
  • Glossary
  • Portable Libraries
• End-of-Life Products
• Contact Support
• Guidelines and Policies
• Security Resources

Removing an MX80 AC Power Supply

Before you remove a power supply, be aware of the following:

Note: The minimum number of power supplies must be present in the router at all times.

Caution: To maintain proper cooling and prevent thermal shutdown of the operating power supply unit, each power supply slot must contain either a power supply or a blank panel. If you remove a power supply, you must install a replacement power supply or a blank panel shortly after the removal.

Note: After powering off a power supply, wait at least 60 seconds before turning it back on.

To remove an AC power supply (see Figure 1):

1. Switch off the dedicated customer site circuit breaker for the power supply, and remove the power cord from the AC power source. Follow the instructions for your site.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
3. Move the AC input switch next to the appliance inlet on the power supply to the off (O) position.
4. Remove the power cord from the power supply.
5. Press the release latch on the left side of the power supply to disconnect the power supply from the chassis.
6. Pull the power supply straight out of the chassis.

Installing an MX80 AC Power Supply

To install an AC power supply (see Figure 2):

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
2. Move the AC input switch next to the appliance inlet on the power supply to the off (O) position.
3. Using both hands, slide the power supply straight into the chassis until the power supply is fully seated in the chassis slot. The power supply faceplate should be flush with any adjacent power supply faceplate or blank installed in the power supply slot.
4. Attach the power cord to the power supply.
5. Attach the power cord to the AC power source, and switch on the dedicated customer site circuit breaker. Follow the instructions for your site.
6. Move the AC input switch next to the appliance inlet on the power supply to the on ( | ) position and observe the status LED on the power supply faceplate. If the power supply is correctly installed and functioning normally, the status LED lights green steadily.