• Supported Platforms
• MX240 Routers

• Related Topics
• MX240 AC Power Supply Description
• Preventing Electrostatic Discharge Damage to an MX240 Router
• MX240 Router AC Power Specifications

Replacing an MX240 AC Power Supply

1. Removing an MX240 AC Power Supply
2. Installing an MX240 AC Power Supply

Removing an MX240 AC Power Supply

Before you remove a power supply, be aware of the following:

Note: The minimum number of power supplies must be present in the router at all times.

Caution: To maintain proper cooling and prevent thermal shutdown of the operating power supply unit, each power supply slot must contain either a power supply or a blank panel. If you remove a power supply, you must install a replacement power supply or a blank panel shortly after the removal.

Note: After powering off a power supply, wait at least 60 seconds before turning it back on.

To remove an AC power supply (see Figure 1):

1. Switch off the dedicated customer site circuit breaker for the power supply, and remove the power cord from the AC power source. Follow the instructions for your site.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.For more information about ESD, see Preventing Electrostatic Discharge Damage to an MX240 Router.
3. Move the AC input switch next to the appliance inlet on the power supply to the off  (O) position.
4. Remove the power cord from the power supply.
5. Unscrew the captive screws on the bottom edge of the power supply.
6. Pull the power supply straight out of the chassis.

Installing an MX240 AC Power Supply

To install an AC power supply (see Figure 2):

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.For more information about ESD, see Preventing Electrostatic Discharge Damage to an MX240 Router.
2. Move the AC input switch next to the appliance inlet on the power supply to the off (O) position.
3. Using both hands, slide the power supply straight into the chassis until the power supply is fully seated in the chassis slot. The power supply faceplate should be flush with any adjacent power supply faceplate or blank installed in the power supply slot.
4. Tighten both captive screws at the bottom of the power supply.
5. Attach the power cord to the power supply.
6. Attach the power cord to the AC power source, and switch on the dedicated customer site circuit breaker. Follow the instructions for your site.
7. Move the AC input switch next to the appliance inlet on the power supply to the on (|) position and observe the status LEDs on the power supply faceplate. If the power supply is correctly installed and functioning normally, the AC OK and DC OK LEDs light steadily, and the PS FAIL LED is not lit.