• Supported Platforms
• MX240 Routers

• Related Topics
• Preventing Electrostatic Discharge Damage to an MX240 Router
• AC Power Cord Specifications for the MX240 Router
• MX240 AC Power Electrical Safety Guidelines and Warnings

Replacing an MX240 AC Power Supply Cord

1. Disconnecting an MX240 AC Power Supply Cord
2. Connecting an MX240 AC Power Supply Cord

Disconnecting an MX240 AC Power Supply Cord

To disconnect the AC power cord:

1. Switch off the dedicated customer site circuit breaker for the power supply, and remove the power cord from the AC power source. Follow the instructions for your site.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.For more information about ESD, see Preventing Electrostatic Discharge Damage to an MX240 Router.
3. Move the AC input switch next to the appliance inlet on the power supply to the off (O) position.
4. Remove the power cord from the power supply.

Connecting an MX240 AC Power Supply Cord

To connect the AC power cord:

1. Locate a replacement power cord with the type of plug appropriate for your geographical location (see AC Power Cord Specifications for the MX240 Router).
2. Connect the power cord to the power supply.
3. Insert the power cord plug into an external AC power source receptacle.
4. Route the power cord appropriately. Verify that the power cord does not block the air exhaust and access to router components, or drape where people could trip on it.
5. Switch the AC input switch on the each power supply to the on (|) position and observe the status LEDs on the power supply faceplate. If the power supply is correctly installed and functioning normally, the AC OK and DC OK LEDs light steadily, and the PS FAIL LED is not lit.