• Downloads
• Installing a Power Supply in an EX3200 or EX4200 Switch    

• Related Topics
• Removing a Power Supply from an EX3200 or EX4200 Switch
• Installing and Removing EX3200 and EX4200 Switch Hardware Components
• Power Supply in EX3200 and EX4200 Switches
• Field-Replaceable Units in EX3200 and EX4200 Switches
• AC Power Cord Specifications for EX3200 and EX4200 Switches
• Rear Panel of an EX3200 Switch
• Rear Panel of an EX4200 Switch

Installing a Power Supply in an EX3200 or EX4200 Switch

The power supply in EX3200 and EX4200 switches is a hot-removable and hot-insertable field-replaceable unit (FRU): You can remove and replace it without powering off the switch or disrupting switch functions.

Ensure that you have the following parts and tools available:

• A Phillips (+) screwdriver, number 2

To install a power supply in an EX3200 or EX4200 switch (see Figure 1):

1. Taking care not to touch power supply components, pins, leads, or solder connections, remove the power supply from its bag.
2. Loosen the locking lever screw on the left front of the power supply by using the screwdriver.
3. Push down on the locking lever until it is in its lowest position.
4. Using both hands, place the power supply in the power supply slot on the rear panel of the switch and slide it in until it is fully seated.

   Note: The handle on the 320 W AC power supply is at the bottom of the power supply faceplate, while the handle on the 600 W and the 930 W AC power supplies is at the top of the faceplate. The handle on the 190 W DC power supply runs across the faceplate.

5. Push the locking lever up to its highest position (this action might pull the power supply in).
6. Tighten the locking lever screw by using the screwdriver.

Note: Each power supply must be connected to a dedicated power source outlet.

Note: If you have a Juniper J-Care service contract, register any addition, change, or upgrade of hardware components at https://www.juniper.net/customers/csc/management/updateinstallbase.jsp. Failure to do so can result in significant delays if you need replacement parts. This note applies if you change the type of power supply or add a new type of uplink module. It does not apply if you replace these components with the same type of component.