Removing an MX80 MIC
MICs are hot-insertable and hot-removable. When you remove a MIC, the router continues to function, although the MIC interfaces being removed no longer function.
In the modular configuration of the MX80 router, the MICs can be installed in two slots in the front of the router. A MIC weighs less than 2 lb (0.9 kg).
To remove a MIC (see Figure 1 and Figure 2):
- Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the MIC. If the MIC connects to fiber-optic cable, have ready a rubber safety cap for each transceiver and cable.
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Use one of the following methods to take the MIC offline:
- Press its online/offline button. Use a narrow-ended tool that fits inside the opening that leads to the button. Press and hold the button until the MIC OK/FAIL LED goes off (about 5 seconds).
- Issue the following CLI command:
user@host> request chassis mic fpc-slot slot-number mic-slot slot-number offline
- Label the cables connected to the MIC so that you can later reconnect each cable to the correct MIC.
- Disconnect the cables from the MIC. If the MIC
uses fiber-optic cable, immediately cover each transceiver and the
end of each cable with a rubber safety cap.
Warning: Do not look directly into a fiber-optic transceiver or into the ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a transceiver emit laser light that can damage your eyes.
Caution: Do not leave a fiber-optic transceiver uncovered except when inserting or removing cable. The safety cap keeps the port clean and prevents accidental exposure to laser light.
- Arrange the cable to prevent it from dislodging
or developing stress points. Secure the cable so that it is not supporting
its own weight as it hangs to the floor. Place excess cable out of
the way in a neatly coiled loop.
Caution: Avoid bending fiber-optic cable beyond its minimum bend radius. An arc smaller than a few inches in diameter can damage the cable and cause problems that are difficult to diagnose.
- Pull the ejector lever above the MIC you are removing
away from the router. Pulling the ejector lever disconnects the MIC
from the chassis.
Note: To remove a dual-wide MIC that takes up both MIC slots, you must pull both ejector levers.
- Grasp the handles on the MIC faceplate, and slide the MIC out of the chassis. Place it in the electrostatic bag or on the antistatic mat.
- If you are not reinstalling a MIC into the emptied MIC slot within a short time, install a blank MIC panel over the slot to maintain proper airflow in the chassis card cage.
Figure 1: Removing a MIC
Figure 2: Removing a Dual-Wide MIC
