Removing a JCS1200 Management Module Filler Tray
Figure 1 shows how to remove and install a management module filler tray.
Figure 1: Removing and Installing a JCS1200 Management Module Filler Tray
To remove a management module filler tray (see Figure 1):
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Remove the management module or filler from the management module bay (see Removing a JCS1200 Management Module or Module Filler).
- Pull the management module filler tray release handle to the open position. The filler tray moves out of the bay approximately 0.25 in. (0.6 cm).
- Slide the filler tray out of the bay.
