Installing an SRX5600 Services Gateway IOC
An IOC weighs up to 14.5 lb (6.6 kg). Be prepared to accept its full weight.
To install an IOC (see Figure 1):
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Place the IOC on an antistatic mat or remove it from its electrostatic bag.
- Identify the slot on the services gateway where it will be installed.
- Verify that each fiber-optic transceiver is covered with a rubber safety cap. If it does not, cover the transceiver with a safety cap.
- Orient the IOC so that the faceplate faces you.
- Lift the IOC into place and carefully align the right and left edges of the IOC with the guides inside the card cage.
- Slide the IOC all the way into the card cage until you feel resistance.
- Grasp both ejector handles and rotate them clockwise simultaneously until the IOC is fully seated.
- Remove the rubber safety cap from each fiber-optic
transceiver and cable.
Warning: Do not look directly into a fiber-optic transceiver or into the ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a transceiver emit laser light that can damage your eyes.
- Insert the cables into the cable connector ports on each IOC (see Figure 2).
- Arrange the cable in the cable manager to prevent
it from dislodging or developing stress points. Secure the cable so
that it is not supporting its own weight as it hangs to the floor.
Place excess cable out of the way in a neatly coiled loop. Placing
fasteners on the loop helps to maintain its shape.
Caution: Do not let fiber-optic cable hang free from the connector. Do not allow fastened loops of cable to dangle, which stresses the cable at the fastening point.
Caution: Avoid bending fiber-optic cable beyond its minimum bend radius. An arc smaller than a few inches in diameter can damage the cable and cause problems that are difficult to diagnose.
- Use one of the following methods to bring the IOC online:
- Press and hold the corresponding IOC online button on the craft interface until the green OK LED next to the button lights steadily, in about 5 seconds.
- Issue the following CLI command:
user@host>request chassis fpc slot slot-number onlineFor more information about the command, see the JUNOS System Basics and Services Command Reference.
Caution: After the OK LED turns green, wait at least 30 seconds before removing the IOC again, removing an IOCfrom a different slot, or inserting an IOC in a different slot.
You can also verify that the IOC is functioning correctly by issuing the show chassis fpc and show chassis fpc pic-status commands.
Figure 1: Installing an IOC
Figure 2: Attaching a Cable to an IOC
